Error Tube


This module creates a tube that connect all the given points. The tube has spheres at the ends. If the input mesh has a scalar node data, it is used to color the tube, otherwise the values 1..N are internally assigned to the nodes. The tube radius is proportional to the point values.

Input Ports

points Mesh or Mesh plus Node_Data The set of points that should be connected by the tube.


Scale slider Scale factor for the radius of the tube to be created.
Facets slider Number of facets for the tube.
Tolerance numeric field Experimental! Smooth the tube reducing the number of intermediate points. The feature is disabled if the value is set to 0.0.

Output Ports

obj DefaultObject The renderable version of the tube.
Return to index